Installation guide

GPON and Active Ethernet UI based zNID
98 FTTH Application Guide
1 In the Network Connections screen you should see the Status as
Connected
The view above is the advanced view (click the Advanced button).
2 Open a DOS window and ping the upstream gateway (provided in your
environment setup)
If you cannot ping it means you do not have data access to your gateway.
If you show connected on the WAN PON and the bridge, it means you
have access on VLAN 200.
You should be able to verify the gateway is up by pinging from the MXK.
On the MXK, just do a normal ping to the gateway as you would from a
DOS window.
If you have access to the gateway from the MXK, do a few bridge stats
commands to verify the bridge is accepting and receiving packets
3 Open a browser to a public site
As long as you can ping you are showing that you have a data path
through the zNID and the MXK to the Internet gateway. As long as that
gateway has access to the Internet you should be able to open a browser
and bring up a page.