Installation guide

GPON and Active Ethernet UI based zNID
86 FTTH Application Guide
Testing the IPTV bridge
Since we are using a laptop and software to emulate a set top box, we can ping
out to the video server.
1 Ping the upstream gateway (provided in your environment setup)
If you cannot ping it means you do not have data access to your gateway.
If you show connected on the WAN PON and the bridge, it means you
have access on VLAN 200.
You should be able to verify the gateway is up by pinging from the MXK.
On the MXK, just do a normal ping to the gateway as you would from a
DOS window.
If you have access to the gateway from the MXK, do a few bridge stats
commands to verify the bridge is accepting and receiving packets
2 Open the STB emulation software and connect to the video server
As long as you can ping you are showing that you have a data path
through the zNID and the MXK to the video server. You should be able to
connect to the video stream with the STB emulation software.