Installation guide

Configuring IPTV, GPON

FTTH Application Guide

Adding bridge on 1-a-5-0/eth

Created bridge-interface-record ethernet5-200/bridge

zSH> bridge-path add ethernet5-200/bridge vlan 200 default

Bridge-path added successfully

2 Add the dowlink to the zNID

Just as with the data bridge, we will be passing single-tagged packets, this

time vlan 999.

DOC-MXK> bridge add 1-4-1-901/gponport downlink vlan 999 tagged

Adding bridge on 1-4-1-901/gponport

Created bridge-interface-record 1-4-1-901-gponport-999/bridge

3 Verify the bridge using the bridge show command

DOC-MXK> bridge show

Type VLAN Bridge St Table Data

-------------------------------------------------------------------------

tls Tagged 160 ipobridge-160/bridge UP D 00:01:47:1a:fe:64

tls Tagged 160 1-4-1-501-gponport-160/bridge UP

tls 160 ethernet4/bridge UP D 00:00:86:43:3c:e4

D 00:00:86:43:ec:69

upl Tagged 999 ethernet5-999/bridge UP S VLAN 999 default

dwn Tagged 999 1-4-1-901-gponport-999/bridge UP D 00:10:a4:b1:f0:bf

D 01:00:5e:0a:0a:0a

dwn Tagged 200 1-4-1-501-gponport-200/bridge UP D 00:01:47:07:1d:fa

upl Tagged 200 ethernet5-200/bridge UP S VLAN 200 default

Because the zNID is already active on the line it does not need to be activated.