Installation guide

GPON and Active Ethernet UI based zNID
82 FTTH Application Guide
1 Discover the open ONTs on the line using the gpononu show command
In the gpononu show command we will limit to the card to reduce the
amount of time the discovery will take. We could even have limited it to
the port as well (gpononu show 4/1). If there are a lot of optical
distribution networks (ODNs) on the MXK, commands like gpononu
show without further qualifiers will attempt to do discovery for all of
them. The more ODNs it does discovery for, the longer it will take.
DOC-MXK> gpononu show 4
Processing list of 512
This command may take several minutes to complete.
Do you want to continue? (yes or no) [no] y
Free ONUs for slot 4 olt 1:
1 2 3 4 5 6 7 8 9 10 11 12
13 14 15 16 17 18 19 20 21 22 23 24
25 26 27 28 29 30 31 32 33 34 35 36
37 38 39 40 41 42 43 44 45 46 47 48
49 50 51 52 53 54 55 56 57 58 59 60
61 62 63 64
Discovered serial numbers for slot 4 olt 1:
sernoID Vendor Serial Number sernoID Vendor Serial Number
5 ZNTS 466425
Free ONUs for slot 4 olt 2:
1 2 3 4 5 6 7 8 9 10 11 12
13 14 15 16 17 18 19 20 21 22 23 24
25 26 27 28 29 30 31 32 33 34 35 36
37 38 39 40 41 42 43 44 45 46 47 48
49 50 51 52 53 54 55 56 57 58 59 60
61 62 63 64
2 Set the discovered sernoID for the zNID
DOC-MXK> gpononu set 4/1/1 5
Onu 1 successfully enabled with serial number ZNTS 466425
Testing the data bridge
To test the connection, we will put the laptop on the LAN 2 port, ping to the
Internet gateway and open a browser. Pinging to the Internet gateway proves
the data path is open.