Installation guide

OMCI based GPON zNID
64 FTTH Application Guide
GEM Port 1-4-4-701/gponport has been created on ONU
1-4-4-1/gpononu.
Adding bridge on 1-4-4-701/gponport
Created bridge-interface-record
1-4-4-701-gponport-300/bridge
3 On MXK, run the bridge show command to view the MAC address of the
connected VoIP phone.
zSH> bridge show
Type VLAN Bridge St Table Data
---------------------------------------------------------------------------------
upl Tagged 100 ethernet5-100/brid UP S VLAN 100 default
dwn Tagged 100 1-4-4-501-gponport-100/bridge UP D 00:00:86:43:3c:e4
upl Tagged 999 ethernet5-999/bridge UP S VLAN 999 default
dwn Tagged 999 1-4-4-901-gponport-999/bridge UP D 00:00:87:44:0c:e7
D 01:00:5e:0a:0a:0a
tls Tagged 300 1-4-4-701-gponport-300/bridge UP D 00:19:c7:02:9c:6b MAC of Phone
tls Tagged 300 ethernet5-300/bridge UP D 00:00:86:43:3c:e4
D 00:00:86:43:ec:69
D 00:01:47:1a:e4:74
D 00:03:e3:97:bb:00
D 00:50:04:78:56:85
D 00:50:04:bf:63:3e
Because a Specific profile is already created on this ONT when configuring
data application, you do not need to create a Specific profile again.
Since you only add the ONT once, you would normally run the gpononu set
command after you have added all the services. You may add service after
activating the ONT, however if you change the OMCI profiles later, you need
to resync or reboot the ONT. See the Step 1 Activate the ONT in the data
application for the command and greater detail on the operation.
Testing the VoIP configuration
1 Connect an ONT downlink POTS port to a VoIP phone.
Make sure the POTS port number matches the one you assigned for voice
service with the Smart OMCI web tool. In this example, you can connect
either POTS 1 or POTS 2 to the PC.
2 Pick up the phone, you should be able to hear the dial tone and be able to
make and receive a phone call.