Installation guide

OMCI based GPON zNID
54 FTTH Application Guide
Make sure to specify value to all the service plan related variables in the
Generic profile. If there is no default or other value given for a variable,
configuration will fail for this ONT when you are activating the ONT
unless updates to the Generic profile or Specific profile to provide a
value.
zSH> gpononu profiles update gen 2510-service-plan1
Generic Profile: 2510-service-plan1
1 "ETH1 Tagging mode: 0-Pass through, 1-Tagging,
2-QinQ"
2 "ETH1 VLAN (VID or COS,VID)"
3 "ETH1 Forward Oper"
4 "ETH2 Tagging mode: 0-Pass through, 1-Tagging,
2-QinQ"
5 "ETH2 VLAN (VID or COS,VID"
6 "ETH2 Forward Oper"
7 "ETH3 Tagging mode: 0-Pass through, 1-Tagging,
2-QinQ"
8 "ETH3 VLAN (VID or COS,VID"
9 "ETH3 Forward Oper"
10 "ETH4 Tagging mode: 0-Pass through, 1-Tagging,
2-QinQ"
11 "ETH4 VLAN (VID or COS,VID"
12 "ETH4 Forward Oper"
13 "Country Code"
14 "POTS1 Dial Number"
15 "POTS1 User Name"
16 "POTS1 Password"
17 "POTS2 Dial Number"
18 "POTS2 User Name"
19 "POTS2 Password"
20 "VOICE VLAN"
21 "SIP Proxy IP"
22 "SIP Host IP Option: 2-static, 3-DHCP"
23 "SIP Host IP"
24 "SIP Netmask"
25 "SIP Gateway"
26 "SIP Domain"
27 "ETH 1 Admin Status: 0-Up, 1-Down"
28 "ETH 2 Admin Status: 0-Up, 1-Down"
29 "ETH 3 Admin Status: 0-Up, 1-Down"
30 "ETH 4 Admin Status: 0-Up, 1-Down"
31 "POTS 1 Admin Status: 0-Up, 1-Down"
32 "POTS 2 Admin Status: 0-Up, 1-Down"
Enter OMCI edit command or [s]ave, [q]uit, [h]elp:h
Available Commands:
E - display edit data (short)
H - display help
L - display edit data (long)
Q - quit without save
S - save and exit
1..n - edit variable #n