Installation guide

Turning Up Your Solution(s)
32 FTTH Application Guide
2 Connect power
a Plug the circle two pin 12V DC power connector of power converter
to 2510 power port.
b Plug the input of power converter into a live AC outlet.
c Verify that the power (POWER) LED on the 2510 is lit green
indicating that local power is on and voltage is good.
3 Connect telephone (POTS) service
a Connect the phone line to a POTS telephone
b Plug the wire pair with RJ-11 connector into one of the 2510 RJ-11
phone jacks.
4 Connect Ethernet service
a Connect a PC with an Ethernet cable
b Plug the Ethernet cable into the ONT RJ-45 Ethernet port.
5 Verify that the zNID has powered up properly
While the zNID is booting the POWER LED should be green and flash.