Installation guide

Turning up the zNIDs (the ONTs)
FTTH Application Guide
31
Turning up the zNIDs (the ONTs)
Both zNIDs follow a similar procedure for turn up:
1 Connect to the network
2 Connect power
3 Connect services
Once the zNIDs are turned up, verify by the LEDs that the zNID has powered
up properly
zNID GPON 2510
The zNID GPON 2510 is an indoor model which has GPON as the upstream
port. The dowstream ports are four Ethernet ports (10/100) and two POTS
ports.
1 Connect to the network
a Remove the side screw which holds the laser lock door.
b Push the corner of the laser lock door to a 15 degree angle and pull
the laser lock door away from the 2510.
c Remove the dust covers from the SC/APC optical connectors. Clean
the connector if necessary
d Plug in the fiber connector to connect the 2510 to the network.
e Reattach the laserlock door onto the 2510 and replace the screw
which holds the door.