Installation guide

Configuring VoIP, Active Ethernet
FTTH Application Guide
105
3 Enter the authentication information
a In the Authentication User Name text box under SIP Account enter
the assigned user name
b In the Authentication Password text box enter the assigned
password
4 Select the phone connection type.
We will use SIP Proxy.
a Select Use SIP Proxy
b In the Host Name or Address text box under SIP Proxy enter the
fully qualified address for the softswitch server.
c In the Registrar Host Name or Address text box under SIP Proxy
enter the fully qualified address for the softswitch server.
d Click OK
Configuring the MXK for VoIP
1 Add a TLS bridge interface on the uplink card
Note: For all of the scenario examples in this application guide
we are using the same uplinks/upstream interfaces, so if you have
already created the uplink/upstream bridge interfaces, you will
not need to recreate the upstream link here.
DOC-MXK> bridge add 1-a-5-0/eth tls vlan 300 tagged
Adding bridge on 1-a-5-0/eth
Created bridge-interface-record ethernet5-300/bridge
2 Add a TLS bridge interface on the GPON line card
DOC-MXK> bridge add 1-13-1-3/eth tls vlan 300 tagged
Adding bridge on 1-13-1-3/eth
Created bridge-interface-record 1-13-1-3-eth-300/bridge
3 Verify the bridge using the bridge show command
DOC-MXK> bridge show
Type VLAN Bridge St Table Data
-------------------------------------------------------------------------
tls Tagged 160 ipobridge-160/bridge UP D 00:01:47:1a:fe:64
tls 160 ethernet4/bridge UP D 00:00:86:43:3c:e4
D 00:00:86:43:ec:69
upl Tagged 999 ethernet5-999/bridge UP S VLAN 999 default
dwn Tagged 999 1-13-1-2-eth-999 UP D 00:10:a4:b1:f0:bf
D 01:00:5e:0a:0a:0a
tls Tagged 300 ethernet5-300/bridge UP D 00:00:86:43:3c:e4
D 00:00:86:43:ec:69