Installation guide

GPON and Active Ethernet UI based zNID
102 FTTH Application Guide
Configuring VoIP, Active Ethernet
Instead of using an uplink-downlink bridge for VoIP, we will use a TLS
bridge. The TLS bridge allows for bridge forwarding table timeouts, so if the
MAC address has timed out, incoming calls from the softswitch will flood the
TLS bridge and relearn the MAC address.
Figure 24: Adding a TLS bridge for voice services
Configuring the zNID for VoIP
1 Add a VLAN ID on the WAN interface as we did when building the data
bridge
a Click Network Connections in the left hand menu pane
b In the Networks Connection page, click New Connection
c In the Connection Wizard screen select Advanced Connection and
click Next
d In the Advanced Configuration screen select VLAN Interface and
click Next near the bottom of the screen
e From the Underlying Device drop down select the physical WAN
port (WAN Ethernet) to associate with the VLAN ID
f In the VLAN ID text box enter the VLAN ID (300), then click Next
g In the Connection Summary screen select Edit the Newly Created
Connection, then click Finish
h From the Internet Protocol drop down in the Configure WAN
Ethernet screen (the interface you just created), select Obtain an IP
Address Automatically.