User`s guide

7990-A2-GB20-00 May 2002
v
About This Guide
Document Purpose and Intended Audience
This guide contains information needed to set up, configure, and operate the
Hotwire Time Division Multiplexer Symmetric High-bit-rate Digital Subscriber Line
(TDM SHDSL) Endpoint, Models 7995 and 7996, and is intended for installers and
operators.
Document Summary
Section Description
Chapter 1, About the TDM
SHDSL Endpoint
Describes the unit’s features and capabilities.
Chapter 2,
Using the
Asynchronous Terminal Interface
Provides instructions for accessing the user interface
and navigating through the screens.
Chapter 3,
Initial Startup and
Configuration
Provides procedures for setting up the user interface
and for configuring the unit using the asynchronous
terminal interface.
Chapter 4,
Configuring the Unit
Using the Internal Switches
Provides procedures for configuring the unit using the
internal switches instead of the asynchronous
terminal interface.
Chapter 5,
Security Presents procedures for creating a login, setting the
effective access levels, and controlling SNMP
access.
Chapter 6,
Monitoring and
Troubleshooting
Describes using the LEDs, status messages, and
network statistics to monitor the unit and detect and
correct problems.
Chapter 7,
Te sting Provides information about available tests and test
setup.
Appendix A,
Configuration
Options
Contains all configuration options, possible settings,
and default settings.
Appendix B,
Standards
Compliance for SNMP Traps
Contains SNMP trap compliance information.
Appendix C,
Connectors, Cables,
and Pin Assignments
Contains connector and interface information.