User`s guide

3. Initial Startup and Configuration
3-12
May 2002 7990-A2-GB20-00
2. Position the cursor in the TFTP Server IP Address field. Enter the TFTP server
IP address or the MCP IP address for the MCP FFS.
The first three digits of the IP address cannot be 000 or greater than 223.
For an MCP FFS, you must include the directory names separated by a
forward slash. For example, type:
/slot_1/020322.cfg
.
3. Position the cursor in the Destination field. Use the spacebar to select a
network destination for the TFTP server. Select DSL if the TFTP server
destination is the DSL link or COM if the TFTP destination is the COM port (if
COM port is set to NetLink, see Table A-7, Communication Port Options, in
Appendix A,
Configuration Options
).
4. Position the cursor in the TFTP Transfer Direction field. Use the spacebar to
select Download from Server or Upload to Server.
5. Position the cursor at the Start Transfer field. Use the spacebar to select Yes.
Press Enter.
When the data transfer is complete, the Transfer Status field changes to
Completed successfully
.
6. Position the cursor at the
Activate new configuration?
prompt and
select Yes to activate a new downloaded configuration. Press Enter.
NOTE:
Configuration option DSL Mode is
not
changed when a new configuration is
loaded. You must change this setting after the new configuration is activated.
See Table A-6, System Options, in Appendix A,
Configuration Options
.