User`s guide

7990-A2-GB20-00 May 2002
2-1
2
Using the Asynchronous
Terminal Interface
User Interface Access
You can communicate with the Hotwire TDM SHDSL endpoint with an
asynchronous terminal interface (ATI) using one of the following methods:
Direct connection through the COM port of the endpoint or through the serial
port of the DSLAM management card.
Telnet session through the Embedded Operations Channel (EOC).
NOTE:
Only one terminal interface session can be active at a time, and another users
session cannot be forced to end.
Security can limit ATI access several ways. To limit user access or set up login
IDs, refer to Chapter 5,
Security
.
Communication Port Settings
Ensure that the device you connect communicates using these settings:
Data rate set to 9.6 Kbps
Character length set to 8
Parity set to None
Stop Bits set to 1