User`s guide

B. Standards Compliance for SNMP Traps
7990-A2-GB20-00 May 2002
B-7
Tests that affect the enterpriseTestStart and enterpriseTestStop traps and the
variable bindings depend on the interface. The specific tests and variable bindings
are described in Table B-6, Tests Affecting enterpriseTestStart/Stop Traps.
Table B-6. Tests Affecting enterpriseTestStart/Stop Traps (1 of 2)
Interface
enterpriseTestStart/Stop
variable bindings Possible Cause
DSL Network ifIndex (RFC 2863)
ifAdminStatus (RFC 2863)
ifOperStatus (RFC 2863)
ifType (RFC 2863)
ifTestType (RFC 2863)
The following objects
control tests in
SNMP-managed devices:
– noTest(0) – Stops the
test in progress.
– testLoopLLB(4) –
Initiates a Local
Loopback.
– testSendLLBUp(7) –
Initiates an LLB Up
message to the remote
unit.
– testSendLLBDown(8) –
Initiates an LLB Down
message to the remote
unit.
enterpriseTestStart – Any
one of the following tests is
active on the interface:
– Line Loopback
– Remote Line Loopback
enterpriseTestStop – No
tests currently running on the
interface.
G.703
ifIndex (RFC 2863)
ifAdminStatus (RFC 2863)
ifOperStatus (RFC 2863)
ifType (RFC 2863)
ifTestType (RFC 2863)
The following objects
control tests in
SNMP-managed devices:
– noTest(0) – Stops the
test in progress.
– testLoopDTLB(3) –
Initiates a DTE
Loopback.
– testLoopRLB(5) –
Initiates a Remote
Loopback.
enterpriseTestStart – Any
one of the following tests is
active on the interface:
– DTE Loopback
– Repeater Loopback
enterpriseTestStop – No
tests currently running on the
interface.