System information

7. CONNECT TO POWER. Insert the round connector of the

transformer’s thin power cord into the jack labeled

POWER. If the transformer has a built-in plug, plug it into

an AC outlet. If the transformer has a separate power

cord, connect the cord to the transformer, then plug the

power cord into an AC outlet.

When the power cord is installed, the router goes through

a power-on self-test. LED Status on page 9 shows how

the LEDs should appear after a successful test.

Installation is now complete.

If your Internet Service Provider (ISP) has instructed you to configure the Hotwire

ADSL/R Bridge/Router using the web interface, or if you would like to use the device as

a router, proceed to Configuring the Hotwire ADSL/R Bridge/Router on page 10.

Note to service provider: Each 6381 on the same subnet requires a unique IP address if

you wish to upgrade firmware or access it using the web interface.

POWER

Transformer