Specifications

4
September 2002 6390-A2-GK40-00
Power-On
When power is applied, the ReachDSL modem performs self-diagnostics and the
PWR LED is on. The self-diagnostics includes a power-on self-test and all of the
LEDs turn on for one second.
Status LEDs
All of the LEDs turn on and off during the power-on self-test. After a successful
self-test, the LEDs should appear as indicated in
BOLD
in the Condition column
below.
Refer to
Troubleshooting
on page 5 for LED indications requiring action.
ReachDSL
TST
LINE ETHERNET
ALMPWR
TX/RX
01-17003
Power – green
Alarm – red
Test – yellow
Transmit/Receive – green
Ethernet Link – green
DSL Line – green
LED Condition Status
PWR
ON
ReachDSL modem has power.
ALM
OFF
ON
No active alarms.
An alarm condition exists.
TST
OFF
ON
No active tests.
The TST LED is on during the power-on self-test and during a
test initiated by the service provider.
LINE
ON
OFF
The DSL link is active and ready to transmit and receive data.
The DSL link has not been established.
TX/RX
ON
OFF
Data transmission is in progress on the DSL line.
The modem is not transmitting or receiving data.
ETHERNET
ON
OFF
The Ethernet connection to the Ethernet hub or PC is active.
No Ethernet 10BaseT device is detected.