Installation guide

2. Installation
2-22 November 2004 8820-A2-GN20-80
Procedure
To adjust the multislot filler plate to cover empty slots:
CAUTION:
Breakaway may cause sharp edges and burrs. Use due care.
1. Count the number of line cards that you will be installing.
— If you are installing fewer than 8 cards, go to Step 2.
— If you are installing cards in Slots 1–8 or 10–17, remove the appropriate
multislot filler plate (use tabs provided).
2. From the side of the multislot filler plate without the EMI gaskets, break away
as many panels as needed.
NOTE:
Be sure to break off panels from the side of the filler plate opposite the EMI
gaskets. The edge with the the EMI gaskets is needed to create a good EMI
seal with the card in the slot to the left of the filler plate.
Multislot Filler Plate
Rear View
Break at Score
99-16261-01
Caution
Label
EMI
Gaskets