User`s guide

Network Configuration Worksheets
A-2
8000-A2-GB21-10June 1997
Management Domain Configuration Worksheets
For the management domain, configure the MCC card, DSL cards, and HotWire
5446 RTUs as follows:
Perform this task . . .
On this screen . . . To access screen . . .
1. Assign an IP address to
the MCC card.
Who Am I screen Power on the HotWire
DSLAM system.
The system displays the Who
Am I screen.
2. Assign an IP address to
the backplane (s1b) on
the MCC card.
(HotWire – MCC)
IP Network screen
From the HotWire – MCC
menu, select:
Configuration → Interfaces →
IP Network
3. Assign IP addresses to
the DSL cards.
(HotWire – MCC)
Configure DSL IP Addr
screen
From the HotWire – MCC
menu, select:
Configuration → DSL
Cards
→ Set IP Address
4. Create default route. (HotWire – MCC)
Static Routes screen
From the HotWire – MCC
menu, select:
Configuration → IP
Router
→ Static Routes
5. Reset the MCC card. (HotWire – MCC)
Card Reset screen
From the HotWire – MCC
menu, select:
Configuration → Card
Status
→ Card Reset
6. Assign an IP address
within the management
subnetwork for each
HotWire 5446 RTU.
(HotWire – DSL)
IP Network screen
From the HotWire – DSL
menu, select:
Configuration → Interfaces →
IP Network
7. Configure a static route
to the NMS (on each
DSL card).
(HotWire – DSL)
Static Routes screen
From the HotWire – DSL
menu, select:
Configuration → IP
Router
→ Static Routes
Use the worksheets in the following sections to record your network configuration
settings. Photocopy the worksheets as needed.
Assign an IP Address to the MCC Card
On the Who Am I screen, assign an IP address to the MCC card.
Access the . . .
By . . .
Who Am I screen Powering on the HotWire DSLAM system.