User`s guide

A-1
8000-A2-GB21-10
June 1997
Network Configuration
Worksheets
A
Overview
This appendix summarizes the mandatory minimum configuration steps and
provides worksheets to assist you in preparing for the configuration of your
HotWire DSLAM network. Use the worksheets to record configuration settings
such as IP addresses and subnet masks for the MCC card, DSL cards, and
RTUs. After the worksheets are completed, you can then configure your network
with the assigned settings.
These worksheets are based on the network model and theories described in this
guide. They map the network theories to the HotWire user interface screens. For
an explanation of the network model and theories, review the chapters in this
guide. For specific information about the user interface screens and fields, see
the
HotWire Digital Subscriber Line Access Multiplexer (DSLAM) User’s Guide .
Summarizing the Network Configuration
In summary, to configure the network:
 The management domain and customer domain IP addresses and static
routes are assigned to the HotWire DSLAM system using the HotWire
software.
 The HotWire 5446 RTU’s management IP address is also assigned from the
HotWire software.
 The customer domain IP addresses and host routes on the HotWire
5446 RTU are assigned by using an SNMP application, such as Paradyne’s
DCE Manager or by using a MIB browser.
 The IP addresses of the end-user systems are assigned by the ISP.