Specifications

9
DSL Access Wiring
" Procedure
1. Attach new wiring to the T1/R1 connectors that will go to the DSL jack from the
punchdown block or NID.
2. Tighten the T1/R1 terminal screws with a flat-blade screwdriver.
99-15485-01
DSL
RJ11
Jack
Central
Office
Punchdown
Block or NID
Customer Premises
POTS/DSL
Local Loop
Demarcation Point
POTS Splitter
DSL
Twisted-pair
Wiring
Endpoint
You are now ready to run the specified wiring to the endpoint location and install a DSL
wall jack. For endpoint installation instructions, refer to Related Documents on page 2.
If the endpoint is not being installed at this time, reconnect the local loop wiring at the
demarcation point.