Specifications

97-15247
POTS Splitter Housing
3
Mounting the POTS Splitter Housing
The POTS splitter can be placed:
H On the outside of the building near the punchdown block or NID, or
H Inside the building.
When mounted outside, the POTS splitter must be installed at or above the height of
the NID, and should be a minimum of three feet above ground.
At the front of the housing, align the housing to open from the right with the rubber
grommet for cable access facing downward. Place the housing upright as shown. Use a
Phillips-head or combination Phillips/slotted-head screwdriver and the screws included
in the package.
If mounting to:
H Cement or cinder block: Use a drill and
3/16″ masonry drill bit to install the two
plastic anchors first. Then, install the two
8–15 x 1″ Type A screws.
H Wood: Install only the two 8–15 x 1″ Type A
screws and discard the plastic anchors.