User`s guide

About This Guide
vii
7800-A2-GB26-80
May 1999
Section Description
Chapter 6 Performing Loopback Modes and Pattern Tests.
Describes how to set loopback modes and send
pattern tests to check the integrity and performance of
a device. Also describes how to use loopback modes
and pattern tests to isolate a problem on a device or
the line.
Appendix A
SNMP Management Connectivity. Gives examples of
management connectivity, including device
configuration.
Glossary Defines acronyms and terms used in this document.
Index Lists key terms, acronyms, concepts, and sections in
alphabetical order.
Documentation Conventions
The DCE Manager can be installed on HP-UX, Solaris, or AIX systems, running
either OpenView or NetView, depending on your operating platform. Chapter 1,
Setting Up the DCE Manager , describes how to install the DCE Manager on each
of these systems. Further chapters describe the use of the DCE Manager under
HP OpenView only. Though the look and feel of the screens differ from running
the DCE Manager with NetView for AIX, the functionality remains the same.
The following conventions are used in this document:
H An
italic typeface separated by arrows (→) indicates a menu selection
sequence, as in the following example:
Administer → DCE Manager → Device Display
H A courier typeface indicates a file name, pathname, or command that
you enter using the keyboard. It can also indicate a field name or value in a
display.
H An italic typeface enclosed in bracket indicates variable information, such as
<
model_number >.