User`s guide

About This Guide
vi
7800-A2-GB26-80
May 1999
H NextEDGEt 9192 and 9195 Multiservices Access System
H FrameSaver SLV 9580 T3 ATM DSU
H ACCULINK Access Controller (AAC), Front Load and Full Expansion
H Digital Access and Cross-Connect System (DACS) Low-Speed Interface
Unit (LSIU)
See Table 1-1, OpenLane DCE Manager Functions, for a complete list of
supported devices.
Document Audience
The DCE Manager can be installed and used on Hewlett Packard (HP-UX), Sun
(Solaris), and IBM (AIX) systems. This guide is intended for those persons who
must administer, monitor, and perform tests on network devices and interfaces. It
assumes that you are familiar with each of the following:
H Supported devices listed in Table 1-1, OpenLane DCE Manager Functions
H OpenView for HP-UX and Solaris systems or NetView for AIX systems
H System and network administration of your operating platform
Document Summary
Section Description
Chapter 1 Setting Up the DCE Manager. Introduces the DCE
Manager and provides you with the information you
need to install the product software and integrate with
OpenView or NetView .
Chapter 2 Using the DCE Manager. Describes how to access and
display devices for use in DCE Manager operations.
Chapter 3
Administering Devices. Describes how to perform
various administrative operations such as polling
devices, managing and unmanaging devices, and
resetting devices.
Chapter 4
Configuring Devices and Device Interfaces . Describes
how to perform DCE Manager configuration
operations, such as displaying and setting parameters
and copying configuration images to another area in
device memory or to a file.
Chapter 5 Monitoring Devices . Describes how to use the DCE
Manager to evaluate the status of devices.