User`s guide

Configuring Devices and Device Interfaces
4-9
7800-A2-GB26-80
May 1999
Modifying the Injection Table
You can modify the address, mask, type, or status of an injection table entry.
" Procedure
To modify an injection table entry:
1. Open a Device Display for a 5446 RTU.
2. Position the cursor over a DSL interface and press the right mouse button.
A pop-up menu appears.
3. Select
Injection Table from the pop-up menu. The IP Injection dialog appears.
4. Click on the entry you want to modify.
5. Change the parameters as appropriate.
6. Click on the Modify button.
Deleting an Injection Table Entry
If an entry in the injection table is no longer valid, you can remove it from the
table.
" Procedure
To delete an injection table entry:
1. Open a Device Display for a 5446 RTU.
2. Position the cursor over a DSL interface and press the right mouse button. A
pop-up menu appears.
3. Select Injection Table from the pop-up menu. The IP Injection dialog appears.
4. Click on the entry you want to remove.
5. Click on the Delete button.