User`s guide

Setting Up the DCE Manager
1-14
7800-A2-GB26-80
May 1999
Removing the DCE Manager
This section describes how to remove the DCE Manager from HP-UX, Solaris, or
AIX operating platforms.
" Procedure
To remove the DCE Manager:
1. Log in as root on the system where the DCE Manager is installed.
2. Set the PATH variable and export the path using the commands for your
operating platform:
— For HP and Sun systems:
PATH=$PATH:/opt/OV/bin:/sbin:/usr/sbin
export PATH
— For AIX systems:
PATH=$PATH:/usr/OV/bin:/etc:/usr/etc
export PATH
3. Stop the OpenView or NetView process:
ovstop
4. Remove the DCE Manager:
attGEMremove
5. Restart the OpenView or NetView process (if you stopped the process in
Step 3):
ovstart
Retaining Event Configuration
When the DCE Manager is installed or removed, the trapd.conf database is
purged of all entries placed there by the DCE Manager. If you specified additional
additional actions for traps associated with a Paradyne device using OpenView,
these actions are deleted also when the DCE Manager is installed or removed.
To keep these actions, you must reenter the data using OpenView or the
trapd.conf database must be modified after installing or removing the DCE
Manager. The following table lists the location of the database for each operating
platform.
Platform
Database Location
Solaris /etc/opt/OV/share/conf/C/#trapd.conf.bak
HP-UX
Version 10
/etc/opt/OV/share/conf/C/#trapd.conf.bak
AIX /usr/OV/conf/C/#trapd.conf.bak