Specifications

3
7. The rights granted under this Agreement may not be assigned, sublicensed or
otherwise transferred by the Licensee to any third party without the prior written
consent of Paradyne.
8. This Agreement and the license granted under this Agreement shall be terminated
in the event of breach by the Licensee of any provisions of this Agreement.
9. Upon such termination, the Licensee shall refrain from any further use of the
Software and destroy the original and all copies of the Software in the possession of
Licensee together with all documentation and related materials.
10. This Agreement shall be governed by the laws of the State of Florida, without
regard to its provisions concerning conflicts of laws.
Introduction to the ENE2044 and ENE2084
Paradyne's ENE2044 and ENE2084 are loop bonding network extenders for Paradyne's
12000 and 4000 IP Broadband Access Concentrators that provide up to 8 Mbps
(ENE2044) or 16 Mbps (ENE2084) of symmetrical bandwidth using E1 lines.
The ENE2044 features four E1 ports and the ENE2084 eight E1 ports, each capable of
up to 2.0 Mbps bandwidth. When used with any Paradyne loop bonding compatible
product, up to eight ports may be used to deliver high-speed bandwidth at any given
distance. Paradyne's loop bonded technology provides automatic load balancing and
fail-over for optimum redundancy and data throughput. In addition the ENE2044 and
ENE2084 support repeaters installed on the E1 loop, ensuring maximum distance and
flexibility.
The ENE2044 and ENE2084 can be connected to any combination of E1 uplink
interface modules, micro interface modules, and network extenders, so long as every
connection pairs a provider and a subscriber unit.
Provider and Subscriber Defaults
The following table highlights the differences between provider and subscriber units.
Table 1. Unit Defaults by Type
Feature Provider Unit Subscriber Unit
Default IP Address: 192.168.254.252 192.168.254.251
Out of Band Management: Over Ethernet Ports Over E1 Ports
Inband Management: Over E1 Ports Over Ethernet Ports
Response to Broadcast ARP
Request by IP Address:
Unit answers. Unit does not answer;
answers only to ARP
request specifying its MAC
address.