User`s manual

enable or disable ports●

set speed, flow control and full duplex mode●

View Port Configuration:

onscreen table of all ports and settings configured in Set Port Configuration

●

Port Statistics:

see the statistics for each port on the Switch

●

Set Trap Destinations:

enter the IP addresses where SNMP traps are to be sent

●

Set Device Community:

define SNMP community names and set access modes for them

●

VLAN Configuration:

set up port-based VLANs

●

Set IP Routing Interfaces:

configure one or more ports as a routing interface

●

Spanning Tree:

enable the Spanning Tree Protocol and set its parameters

●

Command Line Interface:

reach the prompt to configure and manage the Switch using the Command Line interface

●

Warm Start/Shut Down:

reboot or turn off the Switch

●

Quit Console:

exit BitStorm L3S Series Device Manager

●