User`s manual

General System Settings
Command Line
This section explains how you can:
name your Switch
●
set its IP address, subnet mask and default gateway●
set up or change the system password●
set the Switch's internal clock●
view the Switch's hardware and software versions●
upgrade firmware●
>set password creates the system password
Example: >set password
Enter Password: diablo
>set system contact <name>
enters contact information for system support; enter up to 16 text characters
Example: >set system contact Service
>set system location <location>
identifies the switch's network location; enter up to 16 characters
Example: >set system location 3rd floor bldg B
>set system name <name> identifies the switch; enter up to 16 text characters
Example: >set system name Service Department
>set time mm/dd/yyyy hh:mm [:ss]
sets the switch's date and time. Time and date can be set together or individually. If a two-digit
year is entered, its value is added to 2000. Hours must be entered in 24-hour format. If seconds
are not entered, they are assumed to be zero.
Example: >set time 2/5/00 17:30:15
Example: >set time 17:30
Example: >set time 2/5/00
>set timezone <hours> sets the switch time relative to UTC;
valid entries range from -23 to + 24
Example: >set timezone +8
>clear timezone erases the current timezone setting, equivalent to >set timezone 0
Example: >clear timezone
>show time displays the date, time and day of the week. Time is in 24-hour format.
Example: >show time
>show timezone displays the time zone offset from the UTC
Example: >show timezone
66