User`s manual

Finishing the Installation

To finish your installation:

Configure ports using the management interface you prefer.

●

Connect network cables.●

Install MIBs if you are using an SNMP management system other than the BitStorm L3S Series Device

Manager.

●

Set the system password.●

Configuring ports and connecting network cables

You can configure ports and connect the network cables at any time after:

setting the IP address, subnet mask and default gateway

●

upgrading firmware, if required●

rebooting the Switch to have these changes take effect●

For instructions, see:

Configuring the Ports - Console version●

Configuring the Ports - Web version●

Installing MIBs

If you are using any SNMP management system other than the BitStorm L3S Series Device Manager, you must

install the Switch's MIB files on your management workstation. These files are also on the CD shipped with the

Switch.