User`s manual

Mounting in an Equipment Rack
The BitStorm L3S-T Switch and its slaves, the BitStorm L3S-X, fit in most standard 19-inch equipment racks. All
come with hardware that must be attached before mounting.
Important safety instructions
Maximum operating temperature is 40 degrees Celsius.
●
Never restrict the airflow through the device's fans or air vents.●
When installing equipment into a rack, distribute the units evenly. Otherwise, hazardous conditions may
be created by an uneven weight distribution.
●
Connect the unit to a properly rated supply circuit.●
Reliable earthing (grounding) of rack-mounted equipment should be maintained.●
BitStorm L3S-T
The BitStorm L3S-T comes with mounting handles, socket head screws and an Allen wrench. To attach these
handles:
Place the unit right side up on a hard, flat surface with the front facing
you.
●
Locate a handle over the mounting holes on one side of the unit as
shown.
●
Insert the socket head screws and tighten with the supplied Allen
wrench.
●
Repeat the two previous steps for the other side of the unit.●
Insert the unit into a 19-inch rack making sure that the ventilation holes
are not obstructed.
●
Secure the unit in the rack using the rack mount screws provided and a
Phillips head screwdriver.
●
BitStorm L3S-X
The BitStorm L3S-X comes with mounting brackets and Phillips head screws. To attach these handles:
Place the unit right side up on a hard, flat surface with the front
facing you.
●
Locate a bracket over the mounting holes on one side of the unit as
shown.
●
Insert the screws and tighten fully.●
Repeat the two previous steps for the other side of the unit.●
Insert the unit into a 19-inch rack, making sure that the ventilation
holes are not obstructed.
●
Secure the unit in the rack (screws not provided).●
27