User`s manual

Building a Stack

The BitStorm L3S-T can stand alone or be a master controlling of stack of up to three L3S-X switches.

When an EN switch is installed in a stack, you configure all ports on the L3S-X switches using the BitStorm L3S

Series Device Manager on the BitStorm L3S-T.

Basic steps

Install the Stacking Interface Module in the BitStorm L3S-T. See Installing a Stacking Interface.●

Connect the slave switch to the BitStorm L3S-T using the Stacking Interface Cable shipped with the

module as shown here:

●

Connect the correct power cable for your locale to the slave switch and plug it into an electrical outlet.●

Rack mount all switches. See Mounting in a Rack.●

Configure and manage all ports on all stacked switches following the instructions for the BitStorm L3S-T.●