User`s manual

Installing the Gigabit Uplinks
The BitStorm L3S-T has two optional Gigabit uplink modules. The slots for both of these modules are located on
the Switch's front panel shown here:
Installation steps
Unplug the Switch.
●
Remove the blank plate covering the expansion slot by gently inserting the tip of a small, flathead
screwdriver under the plate. Pop off the plate and discard.
●
Slide the expansion module into its slot until it is firmly seated.●
Attach network cables.●
Power on the Switch.●
Check the LEDs on the module to make sure the module is properly installed. If the Link lights are green,
the module is working properly. If an Activity light on the Gigabit module is yellow, the port is operating at
1000Mbps.
●
24