User`s manual

auto-negotiation must be enabled on both ends of the link. With auto-negotiation enabled, Duplex and

Speed cannot be changed. Auto-negotiation cannot be changed on Gigabit uplinks, Ports 25 and 26.

Select full or half in the Duplex field to set the port 's duplex mode. To make full duplex mode work

properly, both ends of the link must be configured to full duplex mode. This field is not available when

auto-negotiation is enabled.

Select yes or no in the Enabled field to bring the port up or down. A disabled port does not transmit any

packets to the connected segment or forward any received packets to the switching backplane.

Select enable or disable in the Flow Control field to set flow control for the port. Flow control and full

duplex mode cannot both be enabled at the same time.

Select Reset Counters to clear all statistics and reset counters to zero.9.

For information on the GARP tab, see GARP - Configuring GVRP.10.

120