User`s manual

Configuring Ports
Web version
Select Ports, under Configuration on the Main Menu. The Port Configuration screen appears:
Moving about the screen
This screen is designed to make configuring ports a very quick and easy task. You can configure any setting for
a single port, a group of ports or all ports at once.
The ports selected are highlighted in blue as shown above.
●
To configure all ports at once, click on Select All.●
To select a single port, click on the port number button.●
To select some ports, you can either Select All, then click on those you want unselected, or you can
choose Invert Selection. Using the screen above as an example, if you choose Invert Selection, Ports 3
- 26 would be selected instead of Ports 1 - 2.
●
Select Clear Selection to delete selected ports from the highlighted group.●
Once you have selected the port or ports you wish to configure, select Modify.1.
If you have selected an individual port, you can enter up to 16 alphanumeric characters in the Name field
to identify this segment.
2.
Type is a read-only field showing whether the port is 10/100Base-TX or 1000Base-SX. Link is a read-only
field showing whether the port is up or down.
3.
Use the Speed to force the port to operate at either 10 Mbps or 100 Mbps. You cannot modify this field if
you have selected a Gigabit uplink, Ports 25 and 26.
4.
Select enable or disable in Auto-Negotiation to set auto-negotiation for 10/100Base-TX ports.
Auto-negotiation decides a port's speed and duplex mode upon linkup. For this setting to work properly,
5.
119