User`s guide

8 March 2005 8900-A2-GZ40-40
4. Insert the bottom edge of the locking pivot bracket inside the lower edge of the
rear panel cutout next to that connector.
5. Align the two connectors.
6. Rotate the connector until it is fully seated.
7. Tighten the captive screw on the top of the cable's connector.
8. If a ferrite choke is supplied with your line card, clamp it around the cable as
close as possible to the chassis. If it fits loosely around the cable, fasten it with
a cable tie.
Locking Pivot
Bracket
Receptacle on Backplane
Rear Panel
Cutout
99-16163d-01
Rotate
99-16163e-01
99-16163f-01
Tighten Screw