User`s guide

8900-A2-GZ40-40 March 2005 7
5. Secure the other end of the Telco 50-pin cable by tightening the captive
pan-head screw.
6. If a ferrite choke is supplied with your line card, clamp it around the cable as
close as possible to the chassis. If it fits loosely around the cable, fasten it with
a cable tie.
Fastening a Cable with Locking Pivot Brackets
Procedure
To fasten a Telco connector to the chassis with locking pivot brackets:
1. Replace the longer captive screw on the cable connector with the #4-40
Phillips pan-head screw shipped in a plastic bag with the BLC.
2. Install the locking pivot bracket onto the cable end of the connector using the
captive screw, as illustrated below.
3. Locate the connector on the back of the chassis that corresponds with the slot
where you installed the line card. Connectors are labeled 2 and 3 on the 8620
chassis, and 1–18 on the 8820 chassis.
01-16900
Anchor
Mount
Telco 50-Pin
Connector
Cable
Tie
Replaced with
Supplied #4-40
Phillips Pan-head
Screw
Locking Pivot
Bracket
Captive #4-40 Phillips-Head Screw
(Part of Locking Pivot Bracket)
Customer-Supplied
Cable with Connector
Replace with a shorter
Captive Screw provided
with the Pivot Bracket
99-16162a-02
Locking Pivot
Bracket