User`s guide
8900-A2-ZZ40-50 8965, 8968, 8975, and 8985 Access Cards 9
4 Insert the bottom edge of the locking pivot bracket inside the lower edge
of the rear panel cutout next to that connector.
5 Align the two connectors.
6 Rotate the connector until it is fully seated.
7 Tighten the captive screw on the top of the cable's connector.
8 If a ferrite choke is supplied with your access card, clamp it around the
cable as close as possible to the chassis. If it fits loosely around the cable,
fasten it with a cable tie.
Locking Pivot
Bracket
Receptacle on Backplane
Rear Panel
Cutout
99-16163d-01
Rotate
99-16163e-01
99-16163f-01
Tighten Screw