User`s guide

.
8 8965, 8968, 8975, and 8985 Access Cards 8900-A2-ZZ40-50
5 Secure the other end of the Telco 50-pin cable by tightening the captive
pan-head screw.
6 If a ferrite choke is supplied with your access card, clamp it around the
cable as close as possible to the chassis. If it fits loosely around the cable,
fasten it with a cable tie.
Fastening a Cable with Locking Pivot Brackets
To fasten a Telco connector to the chassis with locking pivot brackets:
1 Replace the longer captive screw on the cable connector with the #4-40
Phillips pan-head screw shipped in a plastic bag with the BLC.
2 Install the locking pivot bracket onto the cable end of the connector using
the captive screw, as illustrated below.
3 Locate the connector on the back of the chassis that corresponds with the
slot where you installed the access card. Connectors are labeled 2 and 3
on the 8620 chassis, and 1–18 on the 8820 chassis.
01-16900
Anchor
Mount
Telco 50-Pin
Connector
Cable
Tie
Replaced with
Supplied #4-40
Phillips Pan-head
Screw
Locking Pivot
Bracket
Captive #4-40 Phillips-Head Screw
(Part of Locking Pivot Bracket)
Customer-Supplied
Cable with Connector
Replace with a shorter
Captive Screw provided
with the Pivot Bracket
99-16162a-02
Locking Pivot
Bracket