Specifications

6381-A4 Router Users Guide 99
Any incoming packet from LAN Group 1 (layer 3) with a ToS of 22 is mapped to CoS1, the
highest priority, which is normally given to the voice packets.
3. Leave the default value CoS1 in Default Non-IP.
Any incoming packet from LAN Group 1 without an IP is mapped to CoS1, the highest
priority.
4. Click Apply to temporarily activate the settings.
The changes take effect when you click Apply; however, if the RG configuration is not
saved, these changes will be lost upon RG reboot.
5. Repeat step 2-4 to add more rules to LAN Group 1.
Up to 255 rules can be configured for each interface.
Any ToS that have not been mapped to a CoS is treated as CoS6, the lowest priority.
6. Repeat step 1-5 to create rules to another WAN/LAN interface.
Any WAN/LAN interface that is not configured has the default Untrusted mode.
7. To make the change permanent, click Tools and select System Commands. On the
System Commands page, click Save All.
Ingress Static Configuration
The Ingress - Static page enables you to configure a static CoS for all packets received on a
WAN or LAN interface.
To configure Ingress static QoS settings:
1. At the Interface drop-down box, select Ethernet.