Specifications

10 6350-A2-ZN12-30
Status LEDs
When power is applied, the ReachDSL modem performs self-diagnostics and the PWR LED is
on. The self-diagnostics include a power-on self-test during which all of the LEDs turn on for one
second.
All of the LEDs turn on and off during the power-on self-test. After a successful self-test, the
LEDs should appear as indicated in BOLD in the Condition column below.
LED Condition Status
PWR ON ReachDSL modem has power.
ALM OFF
ON
No active alarms.
An alarm condition exists.
TST OFF
ON
No active tests.
The TST LED is on during the power-on self-test and during a
test initiated by the service provider.
LINE ON
OFF
The DSL link is active and ready to transmit and receive data.
The DSL link has not been established.
TX/RX ON
OFF
Data transmission is in progress on the DSL line.
The modem is not transmitting or receiving data.
ETHERNET ON
OFF
The Ethernet connection to the Ethernet hub or PC is active.
No Ethernet 10BaseT device is detected.
ReachDSL
TST
LINE ETHERNET
ALMPWR
TX/RX
01-17003
Power – green
Alarm – red
Test – yellow
Transmit/Receive – green
Ethernet Link – green
DSL Line – green