User`s guide

3. Using the Web Interface
3-14 July 2005 6218-A2-GB20-10
Modem Setup
To configure the DSL modulation type:
Procedure
1. From the Home screen, click on Setup.
2. Under WAN Setup, select Modem. This will bring up the Modem Setup screen.
Leave the default value if your ISP did not provide this information. For most
cases, this screen should not be modified.
Figure 3-9. Modem Setup
The Apply button will temporarily save these settings. To make the change
permanent, click on Tools (at the top of the page) and select System Commands.
At the System Commands page, click on Save All.
Configuring the LAN
To configure LAN parameters, click on Setup on the Home screen. Under LAN
Setup, click on LAN Configuration. The LAN Configuration screen appears.
Enable/Disable DHCP
By default, your CPE has DHCP server (LAN side) disabled. If you already have a
DHCP server running on your network, do not enable a second DHCP server.
To enable DHCP: