Datasheet

CHAPTER 6
Address Translation Parsing Module (ATPM)
54 Vpacket 5100/6100 Series H.323 Telephony
It cannot be part of a valid number. All the digits dialed till the “dial term digit” are considered
valid and the “dial term digit” is discarded. If no parameter is entered, then no dial terminating
digit is configured.
Viewing the system-wide ATMP parameters
To view the system-wide parameters, use the slist command.
Example:
In this example, the dial time is 120000ms or 2 minutes; the interval allowed between picking up
the phone and dialing the first number before the system sends you a busy signal is 30 seconds;
the allowed interval between dialing the numbers of your call is also 10 seconds; the digit you dial
to terminate the call is the pound sign #;, the digit you dial to access an outside line is the 9, your
<dial_out_code> 9 Single number which signals leaving an internal
exchange
<area_code> 2–9 Under the North American Numbering Plan, a
three-digit “toll area” prefix; there are 796.
<office_code> 101–929 First three digits of seven digit local number.
<first_dn> 1000–9999 Local branch exchange numbers begin with
this prefix.
dial_term_digit Optional parameter.
Any valid dial digit
(Values 0 to 9, a, b, c,
d,...*, #)
Digit which indicates end of dial string.
Table 6-5. slist Parameters defined
Parameter Range Description
VPacket(telephony)# atpm slist
System Info: Total dial time = 120000ms, First digit wait =
30000ms,
Interdigit wait = 10000ms, Dial term digit = #,
Dial out code = 9, Area Code = 408, Office Code = 571,
First DN
= 5600
OK
VPacket(telephony)#