Datasheet

ATPM Telephone Address to Hunting Group
Vpacket 5100/6100 Series H.323 Telephony 49
[prefix_number]: Digit to be attached to the beginning of the address before forwarding it. Note
that this optional step of attaching a new prefix address is done only after the previous step of
stripping some prefix digits on the collected digits.
This set of parameters allows for fairly complicated address-mapping schemes to be developed so
Vpacket strongly urges that you have a well-developed plan for assigning values designed
beforehand.
Note. The prefix_number value is an optional parameter, that is, if no number is
entered, no prefix number is configured.
Table 6-1 lists the alist parameters, range, and description of each parameter.
To view a particular member of the list, use the afind <tele_number> command.
To delete a particular member of the list, use the adel <tele_number> command.
To view the address list, issue the atpm alist command.
Table 6-1. alist Parameters defined
Parameter Range Description
tele_number Portion of the total
dialed number to
match
Maximum number of digits that can be dialed. Each digit
can be 0 to 9, a, b, c, d, *, #. (dial-terminating digit cannot be
a part of the tele_number)
min_digits 1 to maximum dial-
able digits
Minimum number of digits to be collected (should be greater
than or equal to the number of digits in tele_number)
max_digits 1 to maximum dial-
able digits
Maximum number of digits to be collected match (should be
greater than or equal to the value of min_digits)
hunt_group_id 0 to maximum
number of Hunt
Groups – 1
Should be greater than or equal to the value of Hunt Groups
set
prefix_strip_
len
0 to maximum
number of digits
you can dial – 1
The number of digits to be stripped at the beginning of the
collected address
[prefix_
number]
1-4 digits Digits to be attached to the beginning of the address before
forwarding it (Attaching a prefix address is done only after
the previous step of stripping some prefix digits on the
collected digits)