Datasheet

Vpacket 5100/6100 Series H.323 Telephony 19
Setting the TCID mode
You can set the operating mode for each TCID (0-23) by issuing the set tcid [tcid] mode
command. The mode is set on a per TCID basis.
Syntax: set tcid [tcid] mode [sw | trans] [cas | ccs | proxy | xgcp]
Arguments:
tcid 0-23; the ID number of the TCID you want to
sw |trans sw is softswitch (choice for H.323)
cas | ccs | proxy | xgcp
cas is channel associated signaling (valid); ccs is clear channel signaling;
proxy; xgcp is MGCP (valid)
Example:
In this example, the mode for TCID 4 is set to use T1 CAS.
set tcid [tcid] cid number
set tcid [tcid] cid time
set tcid [tcid] tone_table
set tcid [tcid] state
set tcid [tcid] copyof
VPacket# tel
telephony# set tcid 4 mode sw cas
OK
telephony#
Table 3-1. (continued) TCID commands
Group Command See...