Datasheet

Vpacket 5100/6100 Series H.323 Telephony 17
Overview
TCIDs are typically configured with the following information:
• A preferred coding profile to use for voice
• An alternate coding profile to switch to when FAX tones are detected
• Other possible coding profiles to use if the preferred voice profile cannot be negotiated
• Additional local configuration parameters
The following sections contain each command with a definition, parameters, and an example to
show how to modify an existing TCID channel description or build a new one.
•The set tcid commands describe and modify the local configuration parameters of the TCID
channel as a whole.
•The set coding commands describe and modify the coding profile attached to the TCID. See
page 29.
•The set h323 commands modify H.323 parameters pertaining to a TCID. See page 35.
Warning. Other coding commands are available in the CLI help, but any changes
made using those other commands are not supported and could adversely affect the
performance of the 5100/6100 VDR.
Caution. Before using any TCID modification commands, Vpacket strongly
recommends that you prepare a backup configuration of your installation as you
have benchmarked it.
TCID commands
Table 3-1 lists all of the TCID-related commands listed in this chapter.
Table 3-1. TCID commands
Group Command See...
TCID set tcid [tcid] mode [sw | trans] [cas | ccs | proxy | xgcp] page 19
set tcid [tcid] voice_prof <prof_id number, -1> page 20
set tcid [tcid] fax_prof <prof_id number, -1> page 20
set tcid [tcid] companding [a_law | mu_law | linear] page 21
WARNING
!