Datasheet

CHAPTER 1
About H.323
6 Vpacket 5100/6100 Series H.323 Telephony
Accessing the telephony commands
The H.323 commands are available within the command line interface (CLI) under the telephony
command shell. Once you establish connectivity to the 6100 VDR either through a
HyperTerminal session or a telnet session, you can access the telephony shell by entering tel and
pressing the Enter key (Figure 1-2).
Figure 1-2. Entering the telephony command shell
Accessing help
Once inside the telephony command shell, you can view a listing of H.323 commands by entering
either the set or show keywords (Figure 1-3).
Figure 1-3. Viewing H.323 help
If you enter a two word combination, you can view the entire list of available commands within
that group. The list contains both basic and advanced commands; so, it is possible to change
parameters that might adversely affect a network.
The commands are listed by group:
• Show commands
• Coding profile parameter command
• TCID parameter commands (including loop start options)
• T1 parameter commands
• H.323-specific commands
• Call quality commands
VPacket# tel
telephony#
VPacket# tel
telephony# set
set tcid
set coding
set h323
VPacket#