System information

3. Commands
4821-A2-GB21-00 July 2004 3-75
Configure Syslog Remote Create
Configure System Location
configure syslog remote create {ip_address} [udp_port]
Minimum Access Level: Administrator
The configure syslog remote create command specifies the IP address to send syslog
messages.
ip_address – The address of a remote Syslog server. The default is 0.0.0.0
The system only supports one remote Syslog server. To change the IP address of the server, the
user enters a new IP address using the configure syslog remote create command. The new IP
address will overwrite the previous address.
udp_port This value specifies the UDP port to be used for sending remote syslog messages. If
no value is specified then the default value will be used. The default port is 514 as specified in
RFC 3164.
Example:
PDYN# configure syslog remote create 135.90.2.1
configure system information system-location { location}
Minimum Access Level: Administrator
The configure system information system-location command stores the location of the
system.
location – Up to 36 printable characters. No spaces are allowed.
Example:
PDYN# configure system information system-location Building_C_First_Floor