System information

3. Commands
4821-A2-GB21-00 July 2004 3-15
Configure IGMP Query Count
Configure IGMP Query Wait Timer
configure igmp {port_id} query-count {count}
Minimum Access Level: Administrator
The configure igmp query-count determines how many quick query messages will be sent to the
subscriber ports in response to a leave message. If no responses are received after this number of
messages then it can be assumed that no subscribers want to be in the multicast group.
In other products this parameter is also referred to as the robustness value or the number of quick query
count.
port_id – Identifies the IGMP DSL port to be configured. Enter “all” for all ports.
count - This parameter specifies the number of Quick Queries that will be generated by the IGMP Proxy
function in response to an IGMP Leave Message. The default is 2. The range is 1 to 10.
Example:
PDYN# configure igmp 1 query-count 2
configure igmp {port_id} query-wait-timer {time}
Minimum Access Level: Administrator
The configure igmp proxy query-wait-timer specifies the time to wait for a reply before issuing another
Quick Query message.
port_id – Identifies the IGMP DSL port to be configured. Enter “all” for all ports.
time - This parameter specifies the time, in tenths of a second, to wait for a reply before issuing another
Quick Query message. The default is 10 (1 second). The range is 0 to 25.5 seconds.
Example:
PDYN# configure igmp 1 query-wait-timer 200