System information

3. Commands
3-14 July 2004 4821-A2-GB21-00
Configure IGMP Snooping Leave Delay
Configure IGMP Snooping Leave Join Delay
configure igmp {port_id} snooping leave-delay {delay}
Minimum Access Level: Administrator
The configure igmp snooping leave-delay command specifies the period of time during which a
multicast stream will continue to be forwarded on an interface after receipt of an IGMP leave message for
that stream.
port_id – Identifies the IGMP DSL port to be configured. Enter all for all ports.
delay - The amount of time, in tenth of seconds, that the multicast stream will continue after the receipt
of a leave message. The default value is 3. The range is 0 to 25.5 seconds in units of tenths of seconds.
Example:
PDYN# configure igmp 1 leave-delay 3
configure igmp {port_id} snooping leave-join-delay {delay}
Minimum Access Level: Administrator
The configure igmp snooping leave-join-delay command specifies the period of time during which
new multicast streams will not be forwarded on a port following a Leave Message for another stream on
that port.
port_id – Identifies the IGMP DSL port to be configured. Enter “all” for all ports.
delay - The amount of time, in tenths of seconds, that a new multicast stream on a port is delayed
following the receipt of a leave message. The default value is 3. The range is 0 to 25.5 seconds in units of
tenths of seconds.
Example:
PDYN# configure igmp 1 leave-join-delay 3