System information
Table Of Contents
- About This Guide
- System Concepts
- CLI Conventions
- Commands
- Typographic Conventions
- Back
- Clear
- Configure
- Configure Bridge
- Configure Bridge Clear
- Configure Bridge Mode
- Configure Bridge Timeout
- Configure Date and Time
- Configure Date-Timezone
- Configure Factory Defaults
- Configure Filter
- Configure Filter Create
- Configure Filter Delete
- Configure Filter Modify
- Configure Filter Protocol-Specific
- Configure Filter-Binding
- Configure Filter-Binding Create
- Configure Filter-Binding Delete
- Configure Filter-Rule Create (L2 filter)
- Configure Filter-Rule Modify (L2 filter)
- Configure Filter-Rule Delete
- Configure Filter Operational Notes
- Configure IGMP Snooping
- Configure IGMP Snooping Leave Delay
- Configure IGMP Snooping Leave Join Delay
- Configure IGMP Query Count
- Configure IGMP Query Wait Timer
- Configure IGMP Proxy Enable
- Configure IGMP Proxy Report Summary Enable
- Configure Interface
- Configure Interface Console Data-Bits
- Configure Interface Console Parity
- Configure Interface Console Rate
- Configure Interface Console Show
- Configure Interface Console Stop Bits
- Configure Interface DSL
- Configure Interface DSL ATM VC Create
- Configure Interface DSL ATM VC Delete
- Configure Interface DSL ATM Encapsulation
- Configure Interface DSL Line-Mode
- Configure Interface DSL Linkupdown Trap
- Configure Interface DSL Name
- Configure Interface DSL Profile Alarm Activate
- Configure Interface DSL Profile Alarm Create
- Configure Interface DSL Profile Alarm Delete
- Configure Interface DSL Profile Alarm Downstream Decreasing Rate
- Configure Interface DSL Profile Alarm Downstream Error Seconds
- Configure Interface DSL Profile Alarm Downstream Increasing Rate
- Configure Interface DSL Profile Alarm Downstream Loss of Frame Seconds
- Configure Interface DSL Profile Alarm Downstream Loss of Signal Seconds
- Configure Interface DSL Profile Alarm Downstream Severely Error Seconds
- Configure Interface DSL Profile Alarm Downstream Unavailable Seconds
- Configure Interface DSL Profile Alarm Show
- Configure Interface DSL Profile Alarm Upstream Decreasing Rate
- Configure Interface DSL Profile Alarm Upstream Increasing Rate
- Configure Interface DSL Profile Alarm Upstream Error Seconds
- Configure Interface DSL Profile Alarm Upstream Loss of Frame Seconds
- Configure Interface DSL Profile Alarm Upstream Loss of Link Seconds
- Configure Interface DSL Profile Alarm Upstream Loss of Power Seconds
- Configure Interface DSL Profile Alarm Upstream Loss of Signal Seconds
- Configure Interface DSL Profile Alarm Upstream Severely Errored Seconds
- Configure Interface DSL Profile Alarm Upstream Init Failure
- Configure Interface DSL Profile Alarm Upstream Unavailable Seconds
- Configure Interface DSL Profile Line Activate
- Configure Interface DSL Profile Line Create
- Configure Interface DSL Profile Line Delete
- Configure Interface DSL Profile Line Latency
- Configure Interface DSL Profile Line Max Interleave Delay Downstream
- Configure Interface DSL Profile Line Max Interleave Delay Upstream
- Configure Interface DSL Profile Line Max-SNR-Margin-Downstream
- Configure Interface DSL Profile Line Max-SNR-Margin-Upstream
- Configure Interface DSL Profile Line Max-Speed-Downstream
- Configure Interface DSL Profile Line Max-Speed-Upstream
- Configure Interface DSL Profile Line Min-SNR-Margin-Downstream
- Configure Interface DSL Profile Line Min-SNR-Margin-Upstream
- Configure Interface DSL Profile Line Min-Speed-Downstream
- Configure Interface DSL Profile Line Min-Speed-Upstream
- Configure Interface DSL Profile Line Rate Adaptive Downstream
- Configure Interface DSL Profile Line Rate Adaptive Upstream
- Configure Interface DSL Profile Line Show
- Configure Interface DSL Profile Line Target-Margin-Downstream
- Configure Interface DSL Profile Line Target-Margin-Upstream
- Configure Interface DSL Profile PSD Atuc-Max-PSD
- Configure Interface DSL Profile PSD Atur-Max-PSD
- Configure Interface DSL Profile PSD Atuc-Max-Tx-Pwr
- Configure Interface DSL Profile PSD Atur-Max-Tx-Pwr
- Configure Interface DSL Profile PSD Atuc-Max-Rx-Pwr
- Configure Interface DSL Queue
- Configure Interface DSL Show
- Configure Interface DSL State
- Configure Interface DSL VLAN PVID
- Configure Interface DSL VLAN Priority
- Configure Interface DSL VLAN Acceptable-Frame-Type
- Configure Interface DSL VLAN Ingress-Filtering
- Configure Interface Ethernet Flow Control
- Configure Interface Ethernet Mode
- Configure Interface Ethernet Rate
- Ethernet Rate Restrictions
- Configure Interface Ethernet Show
- Configure Interface Ethernet Xover
- Configure Interface Ethernet VLAN PVID
- Configure Interface Ethernet VLAN Acceptable-Frame-Type
- Configure Interface Ethernet VLAN Ingress-Filtering
- Configure Management
- Configure Management Default Gateway Address
- Configure Management InBand Address
- Configure Management Out-of-Band Address
- Configure Management Route Add
- Configure Management Route Delete
- Configure Management Route Show
- Configure Management SNMP Access Validation
- Configure Management SNMP NMS Address
- Configure Management SNMP NMS Trap Address
- Configure Management SNMP Read/Write Community String
- Configure Management SNMP Read Only Community String
- Configure Management SNMP State
- Configure Proxy ARP NHR
- Scheduled Configuration Backups
- Configure Scheduled Backup Enable
- Configure Scheduled Backup Dynamic
- Configure Scheduled Backup Fixed
- Configure Scheduled Backup FTP
- Configure Scheduled Backup Time Stamp
- Configure Security
- Configure Security IP (Host Address Limiting) Enable
- Configure Security IP Add Static Address
- Configure Security IP Max Addresses
- Configure Security IP Show
- Configure Security MAC Add
- Configure Security MAC Delete
- Configure Security MAC Show
- Configure SNTP
- Configure SNTP Enable
- Configure SNTP Server Address
- Configure SNTP Interval
- Configure Syslog
- Configure Syslog Rate Limiting
- Configure Syslog Threshold
- Configure Syslog Remote Enable
- Configure Syslog Remote Create
- Configure System Location
- Configure System Name
- Configure System Contact
- Configure System Options Date Display Format
- Configure System Options Inactivity Time Out
- Configure System Options Spectrum Management
- Configure System Options Test Timeout
- Configure Uplink-Tag
- Configure Uplink Tagging Index
- Configure User-Accounts
- Configure User-Accounts
- Configure User-Accounts Delete
- Configure VLAN
- Configure VLAN Create
- Configure VLAN Delete
- Configure VLAN Modify Name
- Configure VLAN Modify Next Hop Router
- Configure VLAN Modify Ports
- Configure VLAN Modify Proxy-ARP
- Configure VLAN Modify Secure VLAN
- Configure VLAN Reserved Block Start
- Configure VLAN Show
- Copy (Configuration)
- End
- Exit
- Firmware
- Paging
- Password
- Ping
- Privilege
- Restart
- Save
- Show
- Show Bridge
- Show Bridge Timeout
- Show Date
- Show Filter
- Show Filter-Binding
- Show Filter-Proto-Specific
- Show Filter-Rule
- Show Interface Console
- Show Interface DSL Far End
- Show Interface DSL Profile Alarm
- Show Interface DSL Profile Line
- Show Interface DSL Profile PSD
- Show Interface DSL Rates
- Show Interface DSL Statistics Line Far End
- Show Interface DSL Statistics Line Near End
- Show Interface Ethernet Clear Statistics
- Show Interface Ethernet Configuration
- Show Proxy ARP NHR
- Show Management ARP Table
- Show Management Default Gateway Address
- Show Management Inband
- Show Management Out of Band
- Show Management Route
- Show Management SNMP Configuration
- Show Management SNMP Statistics
- Show Multicast
- Show Scheduled Backup
- Show Security IP
- Show Security MAC
- Show SNTP
- Show Syslog
- Show Syslog-Remote
- Show System Information
- Show System Options
- Show System Self-Test
- Show System Status
- Show Technical-Support
- Show Uplink
- Show Uplink-Tag
- Show User Accounts
- Show Users
- Show VLAN Configuration
- Show VLAN Reserved Block Start
- Test
- Reference Tables
- Command Summary
- Index

1. System Concepts
4821-A2-GB21-00 July 2004
1-5
1:1 (Lowest Priority Group)
Queue 4 (High)
Queue 3
Queue 2
Queue 1 (Low)
d
spv
d
spv
Select
Packets
2
1
Frames to be
transmitted are
assigned to a PG
based on VLAN ID.
The DSL port PG is
made a member of
the VLAN by using
the
port-id:pg
form
in the VLAN
configuration.
1
1:2
1:3
1:4
1:5
1:6
1:7
1:8 (Highest Priority Group)
VLAN 1
Frames are queued
in each PG
based on the IEEE
802.1p priority
field or FIFO
(configurable per
PG).
2
3
Frames are
selected from the
PG output queues
for transmission.
Frames will be
untagged before
forwarding if the PG
is an Untagged
Member of the
VLAN.
3
4
Output VC (Cell)
Scheduling: All VCs
are AAL5 Strict Priority
PG 8 Queue 4 (High)
to PG 1 Queue 1
(Low).
4
Voice
Video 1
Video 2
Video 3
Video 4
PPPoE
Bridged
VC
Default
Data
VC 0/40
VC 1/33
VC 1/34
VC 1/35
VC 1/36
VC 0/62
VC 0/32
VC 0/35
Priority Group (PG)
VLAN - VC Downstream Flow Example
DSL Port 1
03-17461